Nearshore interpolation

Several Fortran routines in GeoClaw interpolate from the computational grids to other specified points where output is desired (typically using the finest AMR resolution available nearby at each desired output time). This includes:

  • Gauge output (time series at specified locations), see Gauges,

  • fgmax grids (maximum of various quantities over the entire simulation at specified locations), see Fixed grid monitoring (fgmax),

  • fgout grids (output of various quantities on a fixed spatial grid at a sequence of times), see Fixed grid output (fgout).

If the specified location is exactly at the center of a computational cell at the finest AMR level present, then the value output is simply that cell value (which in a finite volume method is really a cell average of the quantity over the cell, but approximates the cell center value to \(O(\Delta x^2)\) if the quantity is smoothly varying.

In general, however, the specified points may not lie at cell centers. In all the cases listed above, the default behavior is to use “zero-order extrapolation” to determine the value at the point, meaning that the value throughout each computational cell is approximated by a constant function (zero degree polynomial) with value equal to the cell average. Hence the value that is output at any specified point is simply the cell average of the (finest level) grid cell that the point lies within.

One might think that a better approximation to the value at a point could be obtained by using piecewise bilinear approximation (in two dimensions): Determine what set of four grid centers the point lies within and construct the bilinear function \(a_0 + a_1x + a_2y + a_3xy\) that interpolates at these four points, and then evaluate the bilinear interpolant at the point of interest. If the function being approximated were smooth then this would be expected to provide an \(O(\Delta x^2)\) approximation, whereas zero-order extrapolation is only \(O(\Delta x)\) accurate.

For GeoClaw simulations, however, we have found that it is best to use zero-order extrapolation because piecewise bilinear interpolation can cause problems and misleading results near the coastline, which is often the region of greatest interest.

The problem is that interpolating the fluid depth h and the topography B separately and then computing the surface elevation eta by adding these may give unrealistic high values. For example if one cell has topo B = -2 and h = 6 (so eta = B+h = 4) and the neighboring cell has B = 50 and h = 0, so that eta = B+h = 50. In the latter case, the elevation eta is simply the elevation of the land and this point is not wet, as indicated by the fact that h=0. But now if we use linear interpolation (in 1D for this simple example) to the midpoint between these points, interpolating the topography gives B = 24 and interpolating the depth gives h = 3. Hence we compute eta = B+h = 27 as the surface elevation. Since the point is apparently wet (h > 0), one might conclude that the sea surface at this point is 27 meters above the initial sea level, whereas in fact the sea level is never more than 6 meters above sea level.